The PD6300 is s 1/8 DIN flow,rate and totalizing meter for analog
output transmitters. They can display flow rate and flow total at
the same time, provide excitation power for the flowmeter. Displays
total, grand total, or non-resettable total on up to nine
Inputs: Field selectable: Pulse or square wave 0-5 V, 0-12
V, or 0-24 V @ 30 kHz; TTL; open collector 4.7 kO pull-up to 5 V @
30 kHz; NPN or PNP transistor, switch contact 4.7 kO pull-up to 5 V
@ 40 Hz; coil (sine wave) 40 mVp-p min @ 10 kHz; Modbus PV
Low Voltage Mag Pickup (Isolated): Sensitivity: 40 mVp-p to
Minimum Input Frequency: 0.001 Hz - Minimum frequency is
dependenton high gate setting.
Maximum Input Frequency: 30,000 Hz (10,000 for Low Voltage
Input Impedance: Pulse input: Greater than 300 kO @ 1 kHz.
Open collector/switch input: 4.7 kO pull-up to 5 V.
Accuracy: ±0.03% of calibrated span ±1 count
Display Update Rate: Total: 10/sec, Rate: 10/sec to 1/1000
Temperature Drift: Rate display is not affected by changes
Multi-Point Linearization: 2 to 32 points
Low-Flow Cutoff: 0-999999 (0 disables cutoff function)
Decimal Point: Up to five decimal places or none: d.ddddd,
dd.dddd, ddd.ddd, dddd.dd, ddddd.d, or dddddd.
Calibration: May be calibrated using K-factor, scale using
internal calibration, or calibrate by applying an external
K-Factor: Field programmable K-factor converts input pulses
to rate in engineering units. May be programmed from 0.00001 to
Calibration Range: Input 1 signal may be set anywhere in the
range of the meter; input 2 signal may be set anywhere above
Filter: Programmable contact de-bounce filter, 40 to 999 Hz
maximum input frequency allowed with low speed filter.
Time Base: Second, minute, hour, or day
Low Gate: 0.1-99.9 seconds
High Gate: 2.0-999.9 seconds